- To see the temperature setting, press and hold the set button for 5 seconds to show the temperature setting To change the temperature setting, use the up or down arrows. **The default temperature setting is 4 degrees Fahrenheit. The set button should be pressed after you have checked or changed the temperature setting.
How do I set the temperature on my dixell?
Temperature Preferences
- The temperature setting may be seen by pressing and holding the set button for 5 seconds. To change the temperature setting, press the up or down arrows. The default value is 4 degrees Fahrenheit. The set button should be pressed after you have checked or changed the temperature setting.
How do you reset a dixell freezer?
Temperatures are being re-set.
- Press and hold the SET button for more than three seconds while either the maximum or minimum temperature is displayed on the display. This will cause the “rSt” warning to appear on the screen. The “rSt” indicator on the controller blinks to indicate that the reset has been completed. Following that, the usual temperature will be displayed on the computer screen.
What does ha mean on a dixell controller?
If the interior compartment temperature exceeds the high temperature alarm preset value for more than 30 minutes, according to the troubleshooting instructions, the control will flash “HA.” It then goes on to discuss some of the causes and possible solutions: Recently, a warm product was placed in the cabinet.
How do you set a dixell?
Press the SET key for more than 2 seconds to change the Set point value; 2. The new set point value will be shown on the screen and the “°C” or “°F” LED will begin to flash. 3. To alter the value of the Set, press either the or arrows.
How do you reset a polar fridge?
If you want to do a soft reset, hold down the UP, DOWN, BACK, and LIGHT buttons at the same time for five seconds until the Polar animation appears on the display. Immediately following the reset, the M460/M400/V800 automatically switches to the time view. Each and every piece of information that you have synced from your Polar device to your Flow account is secure.
Who makes dixell controller?
The Dixell brand is an industrial and commercial electronic regulation and control system manufactured by Emerson US.
What does ha mean on a cooler?
“HA” is the unit’s code for indicating a temperature excursion within the cooling chamber where beverages are kept chilled until consumption. Consider relocating any bigger things that are currently housed within the cooler to verify that none are obstructing the incoming chilly air.
What does P1 mean on dixell controller?
This implies that the thermostat probe has failed. Units equipped with Dixell electronic controls have a “P1” display.
Why is my freezer alarm going off?
It is possible that a sealed system fault such as a refrigerant leak or an inoperable compressor pump is causing the problem if the alarm sounds and you hear the compressor operating. If you suspect a sealed system failure, you should have a service expert inspect the refrigerator. Unplug the freezer and shake it vigorously after removing the start relay.
How do I set the temperature on my eliwell controller?
Setting the Set-point: To show the value of the Set point, press the key while the ‘SEt’ label is displayed on the screen. The value of the Set point is displayed on the display. To alter the Set point value, hit the and keys on your keyboard within 15 seconds of each other. To confirm the change, press the button.